After the computer starts, Windows will automatically scan for hardware changes and reinstall all the USB controllers that you uninstalled. Repeat step d for each USB controller that is listed under Universal Serial Bus controllers, and then click Uninstall to remove it.Į.

Right click the first USB controller under Note: You might have to scroll down the list to find this item.ĭ. Method 2: I would suggest you to disable and re-enable the USB controllers: Then, you can restore the registry if a problem occurs.įor more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:

Therefore, make sure that you follow these steps carefully. However, serious problems might occur if you modify the registry incorrectly. Important: This section, method, or task contains steps that tell you how to modify the registry. Method 1: Perform steps from the link mentioned below and see if it helps in getting the issue resolved.įix: 'This device cannot start' Code 10 error in Device Manager in Windows Device Manager has insufficient information to recognize the error that is bubbled up by the device drive.One of the drivers that the device needs does not start.Were there any changes (hardware or software) made to the computer prior to the issue?Ĭode 10 error is generated in Device Manager in one of the following situations:

Renesas usb 3.0 driver windows 7 32bit